Havis-Shields C-3190-F Bedienungsanleitung PDF herunterladen

C-3190-F-INST-10-06

INSTALL INSTRUCTIONS C-3190-F

1996-2007 FORD CROWN VICTORIA

TOOLS REQUIRED:

7/16” wrench and socket Power Drill and ¼” drill bit

HARDWARE:

QTY

DESCRIPTION PART #

8 ¼-20 x 1” Hex Head Cap Screw GSM33002

12 ¼” Flat Washer GSM31005

12 ¼-20 Hex Head Flange Nut GSM30023

8 ¼-20 x ½” Hex Head Cap Screw GSM33000

4 3/8-16 Hex Nut GSM30008

1 12” – ¼” Loom PRM97913

Step 1. Slide Tray out of housing.

Step 2. Place left and right support arms in place and fasten down with (4) ¼-20 x ½” hex head

cap screws and (4) ¼” flat washers.

Step 3. Place lock arms in place with (4) ¼-20 x ½” hex head cap screws and (4) ¼” flange nuts.

Note: Do not tighten down lock arms at this time. Place ¼-20 x ½” hex head cap

screws from bottom to top on lock arms.

Step 4. Slide tray back into housing. Adjust lock arms then tighten from bottom.

Step 5. Place radio tray on back shelf in trunk. Align rear support bracket with existing holes in

trunk using (4) ¼-20 x 1” hex head screws, (4) ¼” flat washers, (4) ¼” flange nuts and

(4) 3/8-16 hex nut spacers.

Note: On 2005 and newer models, Hex Nut spacers must be installed between rear support bracket and OEM

sheet metal. This will space tray off seat wall so not to crush fuel pump harness. Loom is provided to cover

harness for extra protection.

Step 6. Drill ¼” hole into trunk hinge, support base on drivers and passenger side and fasten

down shelf by using (4) ¼-20 x 1” hex head cap screw, (4) ¼” flat washer and (4) ¼ x

flange nut.

1 2

C-3190-F-INST-10-06 INSTALL INSTRUCTIONS C-3190-F 1996-2007 FORD CROWN VICTORIA TOOLS REQUIRED:7/16” wrench and socket Power Drill and ¼” drill bit

Seite 2

C-3190-F-INST-10-06 TECHNICAL SERVICE BULLETIN Subject: Trunk Tray Installation (Part # C-3190-F: Full Width Tray ) Vehicle: 2005 and newer Ford

Keine Kommentare

Havis-Shields C-3190-F Bedienungsanleitung